Do these panels interfere with jack point access?

Verify clearance at your vehicle's OEM jack point locations before final installation. Most factory jack points are recessed enough to accommodate side skirts, but measure your specific setup before committing fasteners. If interference occurs, you may need to trim or reposition the mounting area slightly.

What surface prep do I need before painting?

Sand the surface with appropriate grit to scuff the finish, then clean thoroughly to remove all dust and residue. Apply your chosen primer and paint system according to the manufacturer's instructions. FRP accepts most automotive finishes — confirm compatibility with your paint supplier if using specialty coatings.

What fastening method should I use for installation?

Determine your attachment points by dry-fitting the panels against the body. Most installations use self-tapping fasteners or rivets through pre-drilled holes. Refer to your vehicle's service manual or installation guide specific to aftermarket body panels for torque specs and hole spacing — do not guess fastener placement.